Flip a melamine charging plate right into a cute door hanger wreath for spring.

I used to be strolling round at Michael’s the opposite day and fell head-over-heals in love with this charging plate within the Easter part. The intense coloured plaid is simply so cute! Proper then and there I made a decision to show it right into a door hanging so I’d have an excuse to purchase it. LOL.

I’ve made a charger plate right into a door hanger earlier than and it turned out nice. You’ll be able to see the fall charger plate wreath right here. It is a enjoyable and straightforward craft undertaking that just about anybody can do. I’ve bought a couple of ideas that can assist you alongside the way in which, so observe together with the directions and don’t miss the video tutorial on the finish of the put up.

Let me present you make your very personal spring charger plate door hanging.

Supplies Wanted

Directions

Remember to watch the video on the finish of this put up when you’ve got any questions on make this craft.

Step 1- Lower a bit of scrapbook paper simply barely bigger than the wood rectangle. Apply a skinny layer of Mod Podge to the wooden, then press the scrapbook paper in place, smoothing out any air bubbles.

Step 2- Use sandpaper to sand away any extra paper hanging off the sides of the wooden. This works greatest when you stroke the sandpaper from entrance to again so the paper doesn’t carry up. That is the trick to getting excellent edges any time you connect paper to wooden. Sanding provides you excellent edges!

Step 3- Apply a high coat of Mod Podge to the paper to assist it maintain as much as the weather outdoors.

Step 4- Make a swag of spring floral stems and use florist wire to carry them collectively within the center.

Step 5- Connect the top of a bit of ribbon to the charger plate. Glue the middle of the swag to the ribbon, then fold the ribbon again down over the florals and glue them in place. This would be the hanging loop. Glue an ornamental bow over the underside of the ribbon loop to cover the seams and for further cuteness.

Step 6- Take away the wire from the ornamental wood decide. When the Mod Podge is dry in your rectangle, glue the boots onto the rectangle, then glue the rectangle onto the charger plate.

A NOTE ABOUT GLUE: I used scorching glue for this undertaking, but when your plate can be in a scorching, sunny space, generally that may trigger the new glue to soften and your undertaking will come unglued. If that’s a potential drawback for you, I like to recommend utilizing the E-6000 glue as a substitute. I’ve no hopes that it’ll get that scorching on my door this spring… it’s method too chilly right here for that! Waaaaaaaaaa… that’s me crying. I miss heat sunshine.

As soon as the glue is dry, your charger plate wreath is able to dangle in your entrance door this spring!

Spring Charger Plate Door Hanger Video Tutorial

Like this undertaking? Pin it!