Fairly than your having the fabric feed again out the entrance of the machine, when the reduce is full, you need the vinyl to feed by way of the again.
The cross cutter on the CAMEO 4 is constructed into the again of the chopping machine. Earlier than you begin chopping you will must perform a little arrange. You should utilize the cross cutter when chopping sheets or rolls of vinyl or HTV.
If you’re chopping a roll of vinyl or warmth switch vinyl on the CAMEO 4, you will need to arrange the inbuilt roll feeder. Sheets could be loaded instantly into the CAMEO 4. With each rolls and sheets ensure you arrange the Web page SetUp panel to point you’re NOT chopping with a chopping mat.
As soon as your design is ready up in Silhouette Studio and also you’re prepared to chop, transfer to the Ship panel.
Click on the small gear in
the underside proper nook of the Ship panel to open the preferences.
From the “Feed Choices” choose the choice to Feed the vinyl by way of the cutter.
You may
then must resolve how far you need the fabric to feed. If you’d like
to trim near the bottom-most reduce line, set the feed distance to “4.0” inches if you wish to trim proper beneath the underside most reduce design on the web page. Shut the Ship Panel Preferences window. (You may need to go
again in and alter this selection again to ‘Return to Origin’ when the reduce
is finished or your whole cuts will proceed to feed out the again.)
Earlier than you ship the design to chop from the software program – transfer to your chopping machine.
Begin by unlocking the cross cutter from the again of the Silhouette CAMEO 4.
Unlock the small tab locks on each side of the trimmer by flipping them down.
This can launch the blade so it isn’t locked into place when it is time to trim the vinyl or HTV.
Ship the design to chop such as you usually would. When the reduce is completed, the vinyl will feed out the again of the machine.
As soon as it does, slide the cross cutter blade from left to proper to trim the vinyl off the roll with a pleasant straight reduce.
Slide the blade again to the left so you’ll be able to lock it again into place. Flip the cross cutter locks again as much as safe the roll trimmer.
To unload the remainder of the roll of vinyl that’s nonetheless underneath the rollers, press the unload button (down arrow) on the CAMEO 4 contact panel till the vinyl has been utterly eliminated.
The Silhouette CAMEO 4 cross cutter could be changed when the blade turns into boring. To pop it out, press the small tabs on both sides down.
Observe: This put up might include affiliate hyperlinks. By clicking on them and buying merchandise by way of my hyperlinks, I obtain a small fee. That is what helps fund Silhouette Faculty so I can hold shopping for new Silhouette-related merchandise to indicate you the way to get probably the most out of your machine!
Get Silhouette Faculty classes delivered to your e-mail inbox! Choose As soon as Each day or Weekly.
