Home Craft DIY Wood Bumblebee for Adorning – Manufacturing facility Direct Craft Weblog

DIY Wood Bumblebee for Adorning – Manufacturing facility Direct Craft Weblog


It is a EASY, but enjoyable mission to assist add cute and kooky touches to your property decor, events, and college settings! Add these bumblebees to desk decors, centerpieces, and even connect to your wreath types for a particular contact for the hotter days forward! These are enjoyable for youths and adults- customise to your liking. Add faces or antennas for extra of a cute look!

Stuff you’ll want:

Let’s collect your provides and let’s get crafting!

First step – Making use of the mod podge

Seize the spherical and/or Coronary heart cutouts which are about 4.5 inches. You’ll apply a even coat of the Mod Podge to the cutout.

Second Step – Add your wallpaper

You’ll take the honeycomb wallpaper and apply it on the highest of the cutouts that you just painted the layer of mod podge to. Take a bank card to assist even out the bumps and wrinkles.

Third Step – Trimming

Right here i attempted the damp paper towel to assist get a pleasant shut tear off with the paper nevertheless it took to lengthy. I took a pair of scissors and was capable of lower the paper at a angle to get good and shut.

Subsequent apply a coat of mod podge on prime to permit the paper to seal.

Fourth Step – Create the stripes

Right here you’ll take 3 stripes of painters tape to put out the “bee” strips on the cutout.

Fifth Step – Paint the stripes

Are available along with your black paint and paint the yellow areas exhibiting in your cutouts. It will assist create a pleasant straight line.

Sixth Step – Paint the physique components

Right here you’ll seize the smaller dimension circle and coronary heart cutouts. I used a 2 inch spherical cutout for the pinnacle and a couple of coronary heart cutouts that measured at 2.5 inches.

The spherical cutouts i painted black for the heads. Then white for the two.5 inch coronary heart cutouts for the wings.

Seventh Step- Assemble the bee

You’ll take your sizzling glue gun and glue the pinnacle and the wings in place.

Eighth Step – Connect the equipment

I grabbed some left over ribbon that i had from different initiatives. This was a 3/8″ black and white ribbon that went effectively. Tied this into a pleasant fancy bow. Then i added a bow out of twine to assist add extra distinction.

Right here you can too add a face or antennas. Customise this to your liking.

That is nice for wreath makers or and summer time themed decor/events.

The way to video

Need to see extra? Discover extra stunning and distinctive initiatives by subscribing to our YouTube Channel right here

  • https://www.youtube.com/@FactoryDirectCraft


Please enter your comment!
Please enter your name here