Embroidering with a twisted needle could be very dangerous because the needle may break whereas the machine features. Place the flat facet of the needle on a flat floor and verify that the gap between the needle and the flat floor is leveled. If the needle is twisted or the tip of the needle is damaged, change the needle with a brand new one. If the gap between the needle and the flat floor isn’t leveled, the needle is bent. Don’t use a twisted needle. 

Flip the machine off – Guarantee to show the machine off earlier than altering the needle, or else accidents may happen if the machine begins embroidering.

Loosen the needle set screw and take away the needle – Maintain the needle along with your left hand, after which maintain the Allen screwdriver in your proper, and switch the needle set screw counterclockwise.  Guarantee to make use of the included Allen screwdriver to vary the needle, or else extreme drive utilized to the needle will trigger it to interrupt. Don’t apply excessive drive when tightening or loosening the needle set screw, or else the machine may get broken. 

With the flat facet of the needle in direction of the machine again, place the needle upwards until it touches the needle bar stopper. Go the needle by way of the opening within the presser foot, after which use the needle-changing software to boost the needle. Maintain the needle-changing software and press the tip of the needle-changing software 1 in to increase the needle mounting champ. Connect the clamp to the needle after which launch the pressed space to clamp the needle. To unclamp the needle, press 1 once more. 

Whereas holding the needle in place along with your left hand, tighten the needle set screw. Use the Allen screwdriver to show the needle set screw in a clockwise route.